Can you see that this concrete stoop covers three rows of siding and that the fourth row sits right on top of the concrete.
Concrete steps and siding.
On average concrete steps cost around 2 000.
James hardie 8 25 in x 144 in hz10 hardieplank beaded cedarmill fiber cement lap siding.
Forms for perpendicular steps go together in essentially the same way the straight concrete steps do.
Concrete absorbs and holds water and most siding and trim materials including fiber cement aren t rated for contact with concrete.
It s available in a variety of sizes and shapes to match many of the old siding shingles installed over the last 60 years.
You are right to be concerned about placing the new concrete step in direct contact with the fiber cement trim or most siding and trim materials for that matter.
To pour concrete steps perpendicularly start by striking a level line on the foundation to mark the height of the landing.
Where your price falls depends on the number of steps and the size of the staircase you need.
While it may not be obvious to anyone that has not framed houses you should be able to tell by where the door sill is that the stoop also covers the rim joist of the floor system.
Editorial advisor mike guertin replies.
This can come from the influence of a high water table or from the subgrade not being properly prepared to withstand the weight of the steps.
Concrete steps and siding i will be pouring concrete steps to replace some wooden ones that have rotted away.
Pouring cement is about 300 per step at 2 feet wide and 11 inches deep including materials and labor.
Concrete steps that have begun to sink pose a problem when it comes to repair.
Most projects range between 900 and 5 000.
James hardie is the world leader in fiber cement siding and backerboard.
We ve been providing a better way to build for over 100 years.
Concrete steps can run either straight forward from an exterior door or at right angles to it.
The reason the steps are sinking is that the subgrade beneath the steps has eroded.
In some cases areas the 3 4 backer rod was too thick so i cut it up the middle with my scissors.